Ethernet Wan; Static Ip; Dynamic Ip; Ppp Over Ethernet - Multitech rCell 500 Series User Manual

Ethernet WAN

To access the Ethernet WAN settings, click Internet Setup. Click Edit next to the Ethernet WAN you want to
configure.
WAN types available are Dynamic IP, Static IP, PPPoE, PPTP, and L2TP.

Static IP

Use this option if your ISP provides a fixed IP address. Enter the appropriate IP address, subnet mask, and gateway
address provided to you. The device will not accept IP addresses that are not in the correct format.
■
WAN IP Address: Enter the provided IP Address.
■
WAN Subnet Mask: Enter the provided subnet mask.
■
WAN Gateway: Enter the gateway address.
■
Primary DNS: Enter the primary DNS IP Address.
■
Secondary DNS: Enter the secondary DNS. Can be left blank if your ISP doesn't supply one.
■ MTU: The default value is 0 (Auto).
■ NAT: Check to enable. If you enable, there will be no NAT mechanism between the LAN and WAN.
■
Network Monitoring: Check to enable.
■
IGMP: Choose Enable or Disable the IGMP snooping function. When enabled, the device will detect all IGMP
messaged exchanged. This prevents multicast flooding on an Ethernet link
■ WAN IP Alias: Some ISPs will provide a fixed IP address for management purposes, enter that into this field.

Dynamic IP

To configure a Dynamic IP the following fields are available:
■
Host Name: This field is optional, but required by some ISPs.
■ ISP Registered MAC address: Enter the registered MAC address, or click Clone to copy your PC's MAC
address.
■
Connection Control: Select the connection control scheme from the list. Options are: Auto-Reconnect
(Always on), Connect-on-Demand, and Connect Manually.
■ MTU: The default value is 0 (Auto).
■
NAT: Check to enable. If you enable, there will be no NAT mechanism between the LAN and WAN.
■
Network Monitoring: Check to enable.
■
IGMP: Choose to Enable or Disable the IGMP snooping function. When enabled, the device will detect all
IGMP messaged exchanged. This prevents multicast flooding on an Ethernet link.
■ WAN IP Alias: Some ISPs will provide a fixed IP address for management purposes, enter that into this field.

PPP over Ethernet

Select this option when your ISP requires a PPPoE connection. This is typically used for ADSL services.
■ IPv6 Dual Stack: Check to enable. Enable this option if your ISP provides one IPv4 and one IPv6 address.
■ PPPoE Account: Enter the account provided by your ISP.
■ PPPoE Password: Enter the password provided by your ISP.
■
Primary DNS: Enter the primary DNS IP Address.
®
MultiConnect rCell 500 Series Router User Guide
BASIC NETWORK
19