Table of Contents
Advertisement
Using Setup Wizard
If you are using a 3G/4G network, verify SIM card has been installed before starting setup. Configure this device
using the web UI. To access the web UI, enter the IP Address into your browser. The default IP Address is
192.168.2.1. If this has been changed, type in the new IP Address. On the login page, type the administrator
password and click Login.
Note:
The default administrator username and password are admin. During the first login, the system
requires you to set a new password.
After logging in, select the appropriate language. From the menu on the left, click Wizard.
1.
To start the Wizard, click Next.
2.
Change the web UI login password. Click Next. (We strongly recommend changing the default password.)
3.
Select the correct Time Zone. Click Next. If auto detection does not work, click Detect Again, and select
manually.
4.
Select the WAN type and address. For fixed line, choose Ethernet WAN. Click Next.
5.
Enter LAN IP address and Subnet Mask. Click Next.
6.
Setup Wi-Fi connection. Change the gateway's SSID, Channel Number, Authentication, and Encryption
Algorithm. We strongly recommend adding authentication and encryption for security. Otherwise, accept
the default settings. Click Next.
7.
Verify the new Wi-Fi settings are correct. Click Apply.
8.
Click Apply and Restart.
VPN Setup Wizard
The VPN setup wizard guides you step by step in creating profiles for IPSec, PPTP, or L2TP VPN connections.
1.
To start setup, click Next.
2.
Select VPN connection. Choose IPSec, PPTP, L2TP, or GRE. Click Next.
®
MultiConnect
rCell 500 R2 Series Router User Guide
If you select Ethernet (Static IP Address), input all your ISP-provided addresses (fixed IP
address). Click Next.
If you select Ethernet (Dynamic IP Address), leave input blank if not required. If your ISP
requires input, enter host name or registered MAC addresses. Click Next.
If you select Ethernet (PPPoE or PPP over Ethernet), input account and password from your
ISP. Use for ADSL for WAN connection. Click Next.
If you select Ethernet (PPTP), input dial-up information if your ISP requests it. Click Next.
If you select Ethernet (L2TP), input dial-up information if your ISP requests it. Click Next.
If you select 3G/4G , choose Auto-Detection or Manual Configuration and enter 3G/4G
network settings. Click Next
If you choose IPSec, select Site to Site for office to office or Dynamic VPN for remote access to
office. For other options, go to Advanced Network > VPN. Input required network
information. Click Next.
If you choose PPTP, select Client to connect device to another PPTP server or Server to have
other PPTP clients connect to the device. Click Next.
If you choose PPTP Client, enter tunnel name, IP/FQDN of PPTP server,
username/password, authentication, and MPPE options. Verify these settings are accepted
by the PPTP server or it will reject the connection. Click Next.
INSTALLING AND USING THE ROUTER
13
Advertisement
Table of Contents
