Table of Contents
Advertisement
Section 3
We at Taylor Company are concerned about the safety of
the operator when he or she comes in contact with the
grill and its parts. Taylor has gone to extreme efforts to
design and manufacture built-in safety features to protect
both you and the service technician. As an example,
warning labels have been attached to the grill to further
point out safety precautions to the operator.
To Operate Safely
NOTICE! DO NOT operate the machine
without reading this operator's manual. This manual
should be kept in a safe place for future reference.
IMPORTANT! This machine is to be used only
by trained personnel. It is not intended for use, cleaning,
or maintenance by children or people with reduced
physical, sensory, or mental capabilities or lack of
experience and knowledge, unless given supervision or
instruction concerning the use of the machine by a
person responsible for their safety. Children should be
supervised to ensure that they do not play with the
machine.
WARNING! This machine must be isolated
from all combustible construction and materials including
but not limited to walls, partitions, furniture, floors,
curtains, paper, boxes, and decorations. Failure to
comply may result in fire and cause destruction and
severe injury.
Safety
This equipment is for use ONLY on noncombustible
floors. Required minimum clearance from combustible
construction: 0 in. back and 1 in. (25 mm) side for cook
grill; 6 in. back (152 mm) and 1 in. (25 mm) side for stage
grill. No clearance required back or side from
noncombustible construction.
CAUTION:
•
Do not obstruct the ventilation openings at the
rear of this appliance.
•
Do not obstruct the flow of air in or around the
grill.
•
Do not store any combustible material on or
near the grill.
WARNING! Avoid injury.
•
DO NOT operate the machine unless it is
properly grounded.
•
DO NOT operate the machine with fuses larger
than specified on the machine's data label.
•
All repairs should be performed by a Taylor
service technician.
•
The main power supplies to the machine must
be disconnected prior to performing installation,
repairs, or maintenance.
•
For Cord-Connected Machines: Only Taylor
service technicians or licensed electricians may
install a plug or replacement cord on the
machine.
•
Machines that are permanently connected to
fixed wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have protective devices to
protect against the leakage of current, such as a
GFI, installed by the authorized personnel to
local codes.
•
Stationary machines that are not equipped with
a power cord and a plug or another device to
disconnect the appliance from the power source
must have an all-pole disconnecting device with
a contact gap of at least 0.125 in. (3 mm) in the
Model L850, L852, L858 Series
Safety
3
3-1
Advertisement
Table of Contents
