Tesla RoboStar iQ400 Plus Manual page 20

1. Unfold the plastic cap and pour water into the tank. Only add water to the tank after removing the
tank from the body of the robotic vacuum cleaner. A slight leakage of residual water may occur
when handling. In this case, immediately wipe the spilled area with a dry cloth.
2. Install the mop cloth on the mop. Lightly moisten the mop cloth with water for faster and
smoother wiping with water. If the mop cloth is dirty after cleaning, you can carefully wash it in
lukewarm water.
3. Carefully insert the tank with the mop cloth holder installed into the body of the robot vacuum
cleaner. Do not pour water on the robotic vacuum cleaner or its interior, the robotic vacuum
cleaner is not waterproof.

Three cleaning levels of water wiping can be set in the phone application.

Do not leave the robotic vacuum cleaner unnecessarily standing in a place without movement or
with water residues in the water tank.

Keep a sufficient amount of water in the water tank for wiping or rinsing the mop.

After cleaning, always empty the remaining water from the water tank, rinse it and dry the mop
cloth.

We recommend wiping the floor with clean water with lukewarm water, the cleaning agent can
cause foaming and thus worsen the dripping of water on the mop cloth or cause streaks on the
floor after it dries.

To get the best result when wiping with water, we recommend using this function in one room and
then moving to another room.

For safety reasons, do not charge the battery with the water reservoir filled with water.
MAINTENANCE
ATTENTION! We recommend performing regular maintenance for the most efficient cleaning possible.
INSUFFICIENT MAINTENANCE MAY RESULT IN DAMAGE TO THE ROBOTIC VACUUM CLEANER AND
VOID WARRANTY.
Before cleaning and maintenance, turn off the robotic vacuum cleaner by pressing button "2". Wipe the
top cover of the robotic vacuum cleaner with a soft, dry or slightly damp cloth. Do not use cleaning
agents to clean the surface of the robotic vacuum cleaner, you could damage its surface.
DUST/WATER TANK - clean or empty into charging station after each cleaning

Empty the Dust/Water tank regularly.

The filling of the Dust/Water tank significantly affects the suction performance of the robotic
vacuum cleaner and the quality of cleaning.

If you wash the Dust/Water tank with water, dry it carefully before re-installing it in the robot