Advertisement
Available languages
Available languages
please avoid direct sunlight.
Black furniture may not be properly detected due to the physical nature of infrared sensors.
A slight impact may therefore occur, which will be dampened by the front bumper.
Make sure a dirt bag is installed in the charging station before starting cleaning.
CHARGING THE BATTERY
Ideal location of the charging station
There must be no obstacles within 1.5 meters in front of the front of the charging station, and within
0.5 meters on the sides. A mirror or other objects with a strong reflection cannot be placed in the area
of the charging base 15 cm above the ground. The base should not be exposed to direct sunlight. Make
sure the charging station is within range of a good quality and strong Wi-Fi signal so it can connect to
a Wi-Fi network while charging.
1.
Connect the charging station to an electrical outlet.
2.
Place the robotic vacuum cleaner in the charging station so that the charging connectors lightly
touch the contacts on the charging station and the battery of the robotic vacuum cleaner will start
charging automatically and the "1" button on the top panel of the robotic vacuum cleaner will
flash slowly. When the battery is fully charged, this button will be lit continuously.
FIRST START
SMART CLEANING
1.
This is the most used cleaning method. The device uses dynamic gyroscopic navigation and thus
moves along a cleaning route that is optimized for the best cleaning of the floor.
2.
Press the "2" button to "Start cleaning" on the robot vacuum or press the "1" or "2" button on the
remote control. When cleaning is started, the robot vacuum cleaner should always be in the
charging station.
3.
To interrupt cleaning/stop the robot vacuum cleaner, press the "2" button on the robot vacuum
cleaner or press the "2" button on the remote control.
CLEANING ALONG THE WALL
Place the robotic vacuum cleaner near the charging station and press the "5" button on the remote
controler "Change cleaning mode" and choose "Along the wall" cleaning. The robotic vacuum cleaner
cleans the area around the perimeter of solid objects (e.g. walls).
SPOT CLEANING
Place the robotic vacuum cleaner near the dirty place and press the "5" button on the remote control
"Change cleaning mode" and select cleaning "Spot cleaning".
MANUAL CONTROL
Press the "Directional buttons" on the remote control and control the robotic vacuum cleaner with the
arrows.
TIME SETTING
Press the "7" button on the remote control to enter the "Time Setting" mode. First, set the hour with the
˄ and ˅ buttons. Then press the > button and set the minutes in the same way. Confirm the set values
by pressing the "7 " button.
Advertisement
