Supervisor/User Password; Ide Hdd Auto Detection - FIC PA-2013 Manual

Hide thumbs Also See for PA-2013:

Table of Contents

Supervisor/User Password

To enable the Supervisor/User passwords, select the item from the Standard

CMOS Setup. You will be prompted to create your own password. Type your

password up to eight characters and press Enter. You will be asked to confirm

the password. Type the password again and press Enter. To disable password,

press Enter twice when you are prompted to enter a password. A message

appears, confirming the password is disabled.

Under the BIOS Feature Setup, if System is selected under the Security Option

field and the Supervisor Password is enabled, you will be prompted for the

Supervisor Password every time you try to enter the CMOS Setup Utility. If

System is selected and the User Password is enabled, you will be requested to

enter the User Password every time you reboot the system. If Setup is selected

under the Security Option field and the User Password is enabled, you will be

prompted only when you reboot the system.

Clear Password

If you forget your password, turn off the system power first and remove the

system unit cover. Locate Jumper CPS and cap it. Remove Jumper CPS and

reset the system. At this point, you will not be asked for the password to

enter Setup.

The IDE Hard Disk Drive Auto Detection feature automatically configures your

new hard disk. Use it for a quick configuration of new hard drives. This feature

allows you to set the parameters of up to four IDE HDDs. The option with (Y)

are recommended by the system BIOS. You may also keys in your own

parameters instead of setting by the system BIOS. After all settings, press Esc

key to return the main menu. For confirmation, enter the Standard CMOS

Setup feature.

BIOS Setup

Table of Contents