Table of Contents
Advertisement
VGA I/O & MEMORY
ON enables the power management timers when a no activity events is
detected in the VGA. OFF disables the PM timer even if a no activity event
is detected. The options are: OFF (Default), ON.
LPT & COM I/O
LPT/COM enables the power management timers when a no activity event
is detected in the LPT and COM ports. LPT (COM) enables the power
management timers when a no activity event is detected in the LPT (COM)
ports. NONE to disable the PM timer even if a no activity event is detected.
The options are: LPT/COM (Default), LPT, COM, NONE.
HDD & FDD I/O
ON will enable the power management timers when no activity event is
detected in the hard drive and floppy drive. OFF disables the PM timer even
if no activity event is detected. The options are: OFF, ON (Default).
Resume on Ring & LAN
An input signal on the serial Ring Indicator (RI) line (in other words, an
incoming call on the modem) awakens the system from a soft off state.
The options are: Enabled (Default), Disabled.
RTC Alarm Resume
Enabled allows you to set the time the system will be turned on from the
system power-off status. The options are: Enabled, Disabled (Default).
Soft-Off by PWR-BTTN
The selection Delay 4 Sec. will allow the system shut down after 4 seconds
after the power button is pressed. The selection Instant-Off will allow the
system shut down immediately once the power button is pressed.
The settings are: Delay 4 Sec. (Default), or Instant-Off.
BIOS Setup
37
Advertisement
Table of Contents
