Cpu To Sram Data Transacting Mode Selection: Sram; Install System Ram Modules; Ram Module Configuration - FIC PA-2013 Manual

Hide thumbs Also See for PA-2013:

Table of Contents

Installation Procedures

CPU to SRAM Data Transacting Mode Selection: SRAM

This jumper allows you to select the CPU to SRAM data read/write mode.

If you install a Cyrix or IBM processor on this motherboard, please set at 2-3

pin pair. Please also read Linear Burst feature of BIOS Setup, Chapter 3 for

more information.

This motherboard provides three onboard DIMM sockets for allowing 3.3V

(unbuffered) EDO/SDRAM DIMM modules. Either 8, 16, 32, 64, 128MB, or

256*MB DIMM can be installed on these three sockets. The maximum total

memory supported is up to 768MB*.

NOTE:

1. * A RAM module of this size was not available for testing at time of

printing.

2. This board only supports 3.3V (unbuffered) EDO/SDRAM modules.

3. ||This motherboard supports DIMMs with data access time of 15ns,

|||||||

|||||||12ns, 10ns, 8ns or less. ECC memory and parity check is also

|||||||supported. Please also refer to the feature of Memory ECC Check of

|||||||Chapter 3 for more information.

4. |If DIMM runs at the speed of 100MHz, it must meet the PC100

|||||||Specification.

Table of Contents