Table of Contents
Advertisement
Maintenance & Servicing (cont.)
Condenser Coil Cleaning
The appliance owner is responsible
a Personal Protective Equipment (PPE) Hazard
Assessment and ensuring adequate protection during
maintenance and cleaning procedures.
Use appropriate tools, safety equipment, and PPE
during installation and servicing.
Risk of electric shock or burn!
• Unplug the appliance or turn off the power supply
before installation or servicing.
•
clean appliance with a pressure washer or
DO NOT
hose.
Coil fins are sharp and metal
Sharp edges!
components can have sharp edges. Take care
when moving, installing, cleaning, servicing, and
maintaining the appliance to avoid cuts.
Risk of eye injury!
eye injury. Eye protection recommended.
The cleaning of the condenser coil is not covered by
warranty!
Page 22 of 28
WARNING!
for performing
Airborne dust and debris can cause
NOTICE!
MODEL SERIES
Required Tools
Required tools include (but may not be limited to) the following:
• Phillips screwdriver or bit driver
• 1/4" nut driver
• 3/8" nut driver
• Stiff bristle brush
• Tank of compressed air
• Vacuum cleaner
• Flashlight
• Eye protection
• Gloves
Procedure
1. Disconnect power to appliance.
2. Remove the front louvered grill from the appliance. See fig. 1
and 2.
3. With a stiff bristle brush, carefully clean accumulated dirt from
the front condenser coil fins See fig. 3.
4. With dirt removed from the surface of the coil, use a flashlight
to verify that you can see through the coil and observe the
condenser fan blade spinning. See fig. 4.
If the view is clear, reinstall louvered grill, connect appliance to
power and verify operation. If the view is still blocked with dirt,
proceed to step 6.
5. Remove the condenser base bolts. See fig. 5.
6. Remove the condenser coil brackets (if applicable).
7. Carefully slide the condensing appliance out (tubing
connections are flexible). Gently blow compressed air or CO₂
through the coil until it is clean.
8. Carefully vacuum any dirt around and behind the condensing
appliance area.
9. Reinstall the coil brackets (if applicable). Then carefully slide the
compressor assembly back into position and bolt it in place.
10. Reinstall the louvered grill, connect power to the appliance,
and verify operation.
06/15/2023
P#975541
truemfg.com
TEC_TM 204 | REV. A | EN
Advertisement
Table of Contents
