Table of Contents
Advertisement
RV Soft Start Accessory
7 Preinstallation
This section describes the bracket preparation required
before installing the device onto the AC unit.
7 .1 Bracket configuration
This section describes the bracket configurations based
on the AC model.
7 .1 .1
Brisk II and FreshJet bracket
configuration
The mounting bracket and z-brackets should already be
assembled and attached to the device.
If the bracket is not assembled and/or not attached to
the device, go to "Bracket assembly" on page 13.
r r
18 Z-bracket direction of slant - Brisk II
Device
q
LEDs
w
1. With the supply side of the device facing you,
determine the z-bracket's direction of slant.
I
The two LEDs visible on the outside cover of
the device are located on the supply side of the
device.
– Brisk II - If the z-bracket slants left, go to
"Installation" on page 16, otherwise go to
step 2.
EN
q q
w w
e e
Supply side
e
Direction of slant
r
– FreshJet - If the z-bracket slants right, go to
"Installation" on page 16, otherwise go to
step 2.
2. Complete steps 1–5 in "Preparing the device" on
page 14.
q q
e e
19 Removing the z-brackets and mounting bracket
Bracket screws
q
Device
w
Z-Brackets
e
3. Using the torque wrench and the #2 Phillips
screwdriver, remove the nuts on the bracket screws.
4. Remove the bracket screws from the mounting
brackets and z-brackets.
5. Switch the brackets so that the slant is in the correct
direction.
6. Confirm that the z-bracket's direction of slant is
correct for the AC unit model.
– Brisk - left slant
– FreshJet - right slant
7. Complete the steps in "Assembling the brackets -
Brisk II" on page 14. to reassemble the brackets to
the device.
Preinstallation
w w
r r
t t
Mounting bracket
r
Nuts
t
13
Advertisement
Table of Contents
