Sip Proxy Server Redundancy; Stuttering Dial Tone On Unconditional Call Forward; User Configurable Call Waiting Permanent Default Setting; User Configurable Timeout On No Answer For Call Forwarding - Cisco ATA-186 Administrator's Manual

Additional SIP Services

SIP Proxy Server Redundancy

SIP proxy server redundancy can be enabled by entering a fully qualified domain name (FQDN) or IP
address (and optional port number) in the GkOrProxy and AltGk parameters, and by configuring the
AltGkTimeOut parameter. If you provide hostnames for GkOrProxy or AltGk, the names are resolved
by the configured DNS. DNS results are hard-coded in cache memory for 10 minutes.
If DNS returns multiple IP addresses, the Cisco ATA uses only the first IP address. If AltGk is set to 0
(disabled) and DNS returns two or more IP addresses for GkOrProxy, then the Cisco ATA uses the first
IP address as the primary proxy and the second IP address as the secondary proxy. If GkOrProxy is an
IP address or DNS returns one IP address, then the backup SIP proxy is not available. A special case
exists if GkOrProxy and AltGk are the same values and are not IP addresses. In this case, the AltGk
parameter is assumed to have the value 0.
Related parameters
•
•
•

Stuttering Dial Tone on Unconditional Call Forward

If unconditional call forwarding is enabled, the Cisco ATA plays a continuous stuttering dial tone when
the telephone handset is picked up. This reminds the user that all incoming calls are forwarded to another
number. For more information, see the
the

User Configurable Call Waiting Permanent Default Setting

This feature allows you to specify the default call-waiting setting for every call on a permanent basis by
means of the service activation and deactivation codes.
Related Parameter
ConnectMode, page

User Configurable Timeout On No Answer for Call Forwarding

This feature allows you to specify the timeout before a call is forwarded to another number on no answer.
This feature is activated by entering the service activation code followed by the phone number and delay.
The entry sequence is as follows:
<Service Activation Code> <Phone Number>
Delay can be from 1 to 255 seconds. If the delay is zero (0) or not provided by the user, the delay
specified in the SigTimer parameter (bits 20-25), which has a default value of 20 seconds, is in effect.
Example
Using the U.S. Call Command parameter string, the U.S. service activation code is #75 and the
deactivation code is #73.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
4-10
GkOrProxy, page 5-10
AltGk, page 5-13
AltGkTimeOut, page 5-13
"Call Forwarding in Sweden" section on page
5-28—Bit 23
Chapter 4
"Call Forwarding in the United States" section on page A-5
A-6.
* <Delay> #
Basic and Additional SIP Services
and
OL-3410-01