Service - H&S 5242 Operator's Manual

EXPELLER
Periodically inspect the expeller teeth for wear or damage. Damaged, broken, or missing expeller teeth
will cause excessive machine vibration. Consult with your local H&S dealer for additional ordering
information.
AUGER & EXPELLER SPEED OPTIONS
The expeller input drive sprocket can be changed by raising the auger and then removing the sprocket
which is retained by a snap ring and set screws.
The auger input drive sprocket change requires removal and disassembly of input shaft.
NOTE: When making sprocket changes, some chain length modifications may be required depending
on the condition of the chain and size of the sprocket installed.
OVERLOAD PROTECTION
When the torque limiting clutch disengages, stop all operation and follow the EMERGENCY SHUTDOWN
PROCEDURE and proced as follows;
1. Disengage the PTO.
2. If an object is lodged in the discharge door opening or inside the tank, raise the discharge door,
then raise the main auger.
3. Shut-off tractor and remove key.
4. Trip the expeller pan to clear any material or objects.
5. Remove any foreign objects from the discharge door opening or inside the tank
6. Close the main shield and resume operation.
IMPORTANT: When resuming operation, place the tractor throttle at idle before engaging the PTO.

SERVICE

-25-