Table of Contents
Advertisement
3 – In Vehicle Test (Non-Rivian vehicles)
3 – In Vehicle Test (Non-RIVIAN vehicles)
Use In Vehicle Test (Non-RIVIAN vehicles) to perform Battery Tests on
in-vehicle batteries using test parameters determined by vehicle VIN (if
optional barcode scanner if present) or through manual entry of battery
In Vehicle Test
parameters. A System Test for Starter and Charging testing is also available.
NOTE: When VIN Entry is enabled (See Chapter 6 - Settings),
test will always associate the in-vehicle battery to the VIN of the vehicle being
tested.
IMPORTANT: To expedite the testing procedure, makes sure Auto Test is en-
abled. (Chapter 6 - Settings) The testing process begins as soon as the clamps
are connected.
The CPX-900 provides a battery decision along with additional detailed information on
battery state of charge and reserve capacity.
select options and when necessary,
Battery Test
1.
Connect the tester clamps to the battery terminals.
2.
Auto Test - If enabled, the tool immediately begins testing the battery.
(See Chapter 6 - Settings)
NOTE:
The testing process uses Conductance Profiling™ technology to determine
battery cranking capability and Reserve Capacity. This additional analysis can take
up to 60 seconds to complete.
3.
At the Main Menu select In Vehicle Test.
4.
Enter Work Order - If enabled, use the displayed keyboard template to Enter Work Order
information. (See Chapter 6 - Settings)
5.
Temperature - when prompted, hold the tester temperature sensor 6 to 12 inches over
the top of the battery being tested.
Select Capture to lock in the live temperature reading.
14
Press to return
to enter or continue to the next step.
Temp Sensor
an In Vehicle Test
to the previous screen,
Midtronics Inc. 7000 Monroe Street Willowbrook, IL 60527
CPX-900
Advertisement
Table of Contents
