Using The Keypad; Out-Of-Vehicle Test - Midtronics PowerSensor Micro700 Instruction Manual

USING THE KEYPAD

Press the ARROW buttons to scroll to menu choices.
Press and hold to rapidly scroll through lists of battery
rating values.
Press the ENTER button to make selections.
Press the BACK button to move back a step.
Press and hold the MENU button to make these options
available:
• PRINT RESULT
• PRINTER SELECT
• VIEW RESULT
When the analyzer's clamps are not connected to a battery or pack,
it will turn itself off after 20 seconds (except while printing) if it
detects you are not using the keypad. This helps prolong the life of
the analyzer's internal battery. (Refer to the section "System Saver.")

OUT-OF-VEHICLE TEST

In the Out-of-Vehicle Test the Micro700 performs a conductance test
on one or more batteries not connected to the vehicle. The analyzer
measures open circuit voltage, cranking amps, and displays a
decision on the battery's condition.
To begin testing, connect the Micro700 to the battery. The display
will turn on and the analyzer will prompt you to enter your test
parameters. Use the ARROW keys to scroll to your selection and
press ENTER.
NOTE: The display will not turn on if you connect the clamps in
reverse polarity (negative to positive and positive to negative).
1. Select the BATTERY TYPE:
GROUP 31
COMMERCIAL
AUTOMOTIVE
USING THE KEYPAD
• VOLTMETER
• PERFORM TEST
• SET ADDRESS
3
• •