Table of Contents
Advertisement
1 – Introduction
BMIS Settings
At the User Credentials screen, enter the Midtronics-provided username, password, Client ID, and
Location ID to access BMIS data management.
Use to highlight the numbers on the displayed keyboard and press
Skip to move to the next step.
NOTE:
If WiFi was not configured in the previous step, the BMIS setup screen is not
displayed.
Username
Rivian@CPX900.com
Password
RivianMdx1!
Client ID
151
Location ID
H02BRE
Dealer Number
Input specific Location ID (4-digit code provided by Rivian).
Shop Settings
Use to enter information about the shop in which the tester will be used.
With the displayed alphanumeric keypad, use to highlight the desired alphanumeric
character. Select to access the lower case and symbol character maps.
Once all of the alphanumeric characters have been entered, select Save or Esc to exit without saving.
Data Collection Consent
Select Accept to acknowledge test data is being collected via BMIS.
Test Preparation
Inspecting the Battery
Before starting the test visually inspect the battery for:
•
Cracked, buckled, or leaking case. If you see any of these defects, replace the battery.
•
Corroded, loose, or damaged cables and connections. Repair or replace them as needed.
•
Corrosion on the battery terminals, and dirt or acid on the case top. Clean the case and termi-
nals using a wire brush and a mixture of water and baking soda.
•
Low electrolyte level. If the electrolyte level is too low, add distilled water to fill up to ½ above
the top of the plates and fully charge the battery. Do not overfill.
•
Corroded or loose battery tray and hold-down fixture. Tighten or replace as needed.
8
Rivian Location ID
Shop Name
Shop Address
Shop Address 2
City
State
Zipcode
Country
Enter your location code
Country
Phone Number
Email Address
Website
(Blank)
(Blank)
Midtronics Inc. 7000 Monroe Street Willowbrook, IL 60527
CPX-900
to select. Press
Advertisement
Table of Contents
