Table of Contents
Advertisement
Programming
7. Programming
7.1
Front panel programming
The three buttons are used to program the RCM-2000 for a specific application, as
well as other features.
7.1.1 Menu structure
The unit is setup and programmed from the front panel. The menu structure
is a "drill down" structure with menus and submenus providing access to
specific programming parameters and allowing certain options and features
to be selected. There are 6 main menus with a set of submenus for all but
one of the main menus.
7.1.2 Pushbutton key function
E
When entering numerical values, a flashing cursor appears on the number
to be changed. The programming parameter is changed using a decade
increasing method to speed up programming. By pressing and holding the
up or down key the least significant digit is changed 10 times then the next
significant digit begins to change until it has change 10 times. This continues
up into the most significant digit until the key press is terminated. Most all of
the programming values will rollover from max to min or max to min values.
7.2
User output programming
Installation and operation manual • Version RCM-10/03-e
The UP key is used for scrolling a menu selection or increasing a
programmable parameter
The Right key is used to select a menu item or decreasing a
programmable parameter.
The Enter key allows you access the next menu or to store
programming values.
These menus are entered by first pressing the Enter
key.
Use the up arrow to move the > prompt next to
outputs location on the screen, then press the right
arrow key to select the next set of menus.
Press the up arrow key until the prompt > is next to
change then press the right arrow key to enter the
analog output adjustment menus.
Page 10/18
Advertisement
Table of Contents
