Table of Contents
Advertisement
4. If the Wilger-to-Square lug tip adapters are needed to accommodate the tips, install those on the outlets of the
nozzle bodies by rotating them a quarter turn.
FIGURE 6. Wilger Nozzle Body Assembly with Tip Adapter Installed
MILLENNIUM SPRAY BOOMS INSTALLATION
1. Remove the existing nozzle bodies from the spray boom if necessary.
NOTE:
If ProStop-E valves are installed, please see the next section for removal and re-installation.
Leave all cables connected to the ProStop-E valves; they can be utilized and controlled by the
Hawkeye® 2
system on the second outlet of the nozzle body.
2. Install the Wilger nozzle bodies with 5-way turrets on the spray boom by aligning the inlet with the hole in the
boom tube at each location.
3. Close the clamp and tighten the screw to secure.
Nozzle Body and Nozzle Control Valve Installation: Hawkeye® 2 Nozzle Body Installation
NOZZLE BODY AND NOZZLE CONTROL VALVE INSTALLATION
Tip Adapter
Installed
27
Advertisement
Table of Contents
