Table of Contents
Advertisement
CHAPTER 4
AGCO NOZZLE BODIES INSTALLATION
NOTE:
The Center Rack and first three locations on the primary boom to the left and right of the center rack
will use the Saddle with Integrated Nozzle + End Body configuration. These locations do not have the
structural boom tube running below the wet boom tube, thus it does not interfere with the spray
pattern. Refer to image "A" in Figure 3 on page 25.
Every other location on the spray boom will use the Side Take-off Saddle + Thru Body + End Body
configuration. These locations have the structural boom tube that runs directly below the wet boom
tube, thus the nozzle outlets need to be offset behind this tube. Refer to image "B" in Figure 3 on
page 25.
1. Remove the existing nozzle bodies on the spray boom, if necessary.
2. Install the Wilger nozzle bodies on the spray boom by aligning the inlet with the hole in the boom tube in each
location.
3. Close the clamp and tighten the screw to secure.
MILLENNIUM SPRAY BOOMS ASSEMBLY
NOTE:
Millennium spray booms can accommodate the Wilger dual outlet with 5-way turret configuration in
every location.
1. Locate the components provided to assemble the nozzle bodies.
FIGURE 5. Wilger Dual Outlet with 5-Way Turret Assemblies
2. Remove the stainless steel U-clip provided with the nozzle bodies.
3. Align the 5-way turret body or plug as necessary and reinstall the U-clip to secure, observing the "This Side
Down" indicator on the 5-way turret.
26
Hawkeye® 2 Installation Manual for AGCO RoGator C-Series (RG900, RG1100, RG1300)
This Side
Down
Advertisement
Table of Contents
