Table of Contents
Advertisement
AGCO SPRAY BOOMS NOZZLE BODY ASSEMBLY
1. Locate the components provided to assemble the two configurations of the nozzle bodies.
FIGURE 3. Wilger Nozzle Body Configurations
Center Section
of Machine
A
2. Remove the stainless steel U-clip provided with the nozzle bodies.
3. Align the nozzle body or plug as necessary and reinstall the U-clip to secure.
4. If the Wilger-to-Square lug tip adapters are needed to accommodate the tips to be used, install them on the
outlets of the nozzle bodies by rotating them a quarter turn.
FIGURE 4. Outlets of the Nozzle Body
Nozzle Body and Nozzle Control Valve Installation: Hawkeye® 2 Nozzle Body Installation
NOZZLE BODY AND NOZZLE CONTROL VALVE INSTALLATION
Boom Wings
B
Square Lug Tip
Adapters Installed
25
Advertisement
Table of Contents
