Table of Contents
Advertisement
5.7
Securing the burner to the boiler
Prepare a suitable lifting system using the rings
3)(Fig. 12), after removing the fixing screws 7) of
the casing 8).
Fit the heat insulation supplied onto the blast tube (4)
(Fig. 12).
Fit the entire burner onto the boiler hole prepared previously
(Fig. 11), and fasten with the screws supplied.
The seal between burner and boiler must be
airtight.
WARNING
5.8
Access to head internal part
After you have uncoupled the head movement lever tie-rod
1) and removed the 4 fixing screws 2), open the burner on
the hinge (Fig. 13),
Unhook the probe cables and electrode 3).
Tighten the underneath part of the elbow 4) until it is
released from its housing.
Remove the internal part of the head 5).
5.9
Probe-electrode position
Check that the probe and the electrode are placed
as in Fig. 14, according to the dimensions indicat-
ed.
WARNING
20.5
Installation
20065578
Electrode
Probe
D11735
19
GB
20065562
Fig. 12
Fig. 13
7
Fig. 14
20041914
Advertisement
Table of Contents
