7.3
Opening the burner
Disconnect the electrical supply from the burner
by means of the main system switch.
DANGER
Close the fuel interception tap.
DANGER
Wait for the components in contact with heat
sources to cool down completely.
7.4
Closing the burner
Refit following the steps described but in reverse order; refit all
burner components as they were originally assembled.
Carry out all maintenance work and mount the
casing again.
20041914
20065579
Maintenance
Remove the tie-rod 1)(Fig. 33) of the head movement lever,
undoing the nut 2).
Disconnect the socket 3) of the gas servomotor.
Disconnect the socket 4) of the gas pressure switch.
Remove the screws 5).
At this point, it is possible to open the burner on the hinge.
30
GB
Fig. 33