Usb Pen Drive; Standby Mode - W&H Lexa MN-111 Instructions For Use Manual

USB pen drive

DESCRIPTION
A USB pen drive is available to be installed in order to automatically
record all the sterilization cycle reports. The USB pen drive can be
inserted equally into the front or rear port.
Notice: periodically remove the USB pen drive to save the cycle data
on a computer or on another safe support.
FORMAT THE USB PEN DRIVE
Insert the USB pen drive in one USB port.
1
On the homepage, tap
2
Tap .
3
Tap to confirm: all data will be erased.
4
Tap to confirm and go back to the previous page.
5
Notice: formatting erases all data from the pen drive. Be sure you
have already saved your data on a safe support before formatting.
Lexa | Instructions for Use | MN-111 ENG Rev14 | 03/04/2023 | © W&H Sterilization Srl
> > >

Standby mode

DESCRIPTION
When in Standby mode, the sterilizer display remains dark and the
sterilizer chamber is not heated to save energy. If the sterilizer is not
used for three hours, it automatically switches to Standby mode.
ENTER THE STANDBY MODE MANUALLY
Homepage
1
Tap .
2
EXIT THE STANDBY MODE
Tap or open or close the chamber door.
CHANGING STANDBY MODE DELAY TIME
On the homepage, tap
1
Tap or to change the delay time.
2
Tap to confirm and go back to the previous page.
3
> >
Getting started
37