Label Printer Usage (Optional) - W&H Lexa MN-111 Instructions For Use Manual

Managing printers
SELECT AND CALIBRATE A LOCAL LABEL PRINTER
On the homepage, tap
1
Tap : the local printer is located automatically.
2
Tap to center the printout properly in the label area.
3
Tap to print a test label.
4
If the printout is not duly centered, tap
5
horizontally (x) and vertically (y).
If necessary, tap to print another test label and repeat step
6
4.
Tap to confirm the settings and go back to the previous
7
page.
SELECT A SHARED LABEL PRINTER
Note: function available only if the LAN/Wi-Fi connection has been activated
(optional).
Ensure the sterilizer to which the printer is physically
1
connected is ON and no cycle is running.
From that sterilizer, tap
2
42
> > >
or to center it
> .
Depending on the LAN connection, take note of the Ethernet or
3
Wi-Fi IP address.
Do not switch OFF the sterilizer until the whole procedure is
4
complete.
From the sterilizer from which the printer is not physically
5
connected, tap homepage >
Tap .
6
Tap the text box and enter the IP address previously noted.
7
Tap to confirm.
8
From the sterilizer to which the printer is connected, confirm
9
the printer sharing.
Tap again to print a test label.
10

Label printer usage (optional)

CAUTION! For your safety and the safety of your patients
use a storage time compliant with the recommendations of
the manufacturers of the containters/packaging used, and
with applicable norms and rules.
FUNCTION AVAILABILITY
The first time you access the Label Printer (
requested to enter an activaction code. To require the activation
Lexa | Instructions for Use | MN-111 ENG Rev14 | 03/04/2023 | © W&H Sterilization Srl
> > > .
) menu, you will be