Sterilizer Setup - W&H Lexa MN-111 Instructions For Use Manual

Getting started

Sterilizer setup

GUIDED CONFIGURATION
At the first start- up of the sterilizer, the Guided Configuration
procedure automatically appears; this procedure allows to set some
parameters of the unit, such as:
Language
n
Network connection (where applicable)
n
Time zone settings
n
Date & time settings
n
Sterilizer name
n
At any time, to force the Guided Configuration:
On the homepage, tap
1
Follow the Guided Configuration on the sterilizer screen.
2
SET THE DATE AND TIME
To change the date and time format, current date and time and time
zone:
On the homepage, tap
1
Tap the value you want to change (format, time, date and/or
2
time zone).
Tap the desired value.
3
Tap to confirm and go back to the previous page.
4
34
> > >
> >
SET THE STERILIZER NAME
To change the sterilizer name that appears in the cycle reports:
On the homepage, tap
1
Tap the text box: a keyboard appears.
2
Enter the new sterilizer name.
3
Tap to confirm.
4
SET THE DISPLAY BRIGHTNESS
To change the display brightness:
On the homepage, tap
1
Tap or to change the value.
2
Tap to confirm.
3
CONNECT TO A NETWORK
If you connect through an Ethernet cable, in most cases the sterilizer
will connect to the network automatically. If it does not connect
automatically, or if you are using a Wi-Fi dongle key, follow the
following procedure under supervision of your IT manager / network
administrator.
Lexa | Instructions for Use | MN-111 ENG Rev14 | 03/04/2023 | © W&H Sterilization Srl
> > >
> >