Elitrace (Optional) - W&H Lexa MN-111 Instructions For Use Manual

Getting started
PIN MANAGEMENT
PIN "0000" is assigned as default to each new user. It has to be
changed at the first login. When the PIN is reset the default value
"0000" is reassigned.
CHANGE YOUR PIN
Change your PIN the first time you use the sterilizer and if your PIN
has been reset. This will prevent other users to use your account.
On the homepage, tap
1
Tap your user name.
2
Enter your current PIN and tap
3
Tap .
4
Enter your new PIN and tap
5
message with your new PIN appears.
Tap and then to go back to the previous page.
6
WHAT TO DO IF YOU FORGET YOUR PIN
If...
you are a common user
you are the administrator
36
> > >
to confirm.
to confirm: a confirmation
Then...
contact the administrator
contact your authorized service provider

EliTrace (optional)

FUNCTION AVAILABILITY
To access the EliTrace functions the EliTrace activation code must be
entered. The activation code is required only at the first access to
the EliTrace ( ) menu: after the code was entered, the function is
enabled and there is no need to enter the code again.
To acquire the activation code please refer to the activation code
instructions.
DESCRIPTION
EliTrace allows to know exactly which instruments were sterilized
and link them to a specific cycle.
ACCESS TO ELITRACE
For the EliTrace access proceed as follows:
On the homepage tap
1
Note: for more information see the dedicated documentation.
Lexa | Instructions for Use | MN-111 ENG Rev14 | 03/04/2023 | © W&H Sterilization Srl
> > >