Roland U-8ST Getting Started Manual page 60

Creating Songs with the U-8 and Cubasis VST
What are Insertion Effects and System Effects?
Insertion effects, which are used when recording guitars and mic sources,
are applied to a single input, whereas the System effects are used for
adding effects to the overall mix. As shown in the figure below, when
System effects are used, the signals are sent to the effect from the inputs
little by little, and the effect output is mixed with the source sound.
fig.ins-sys.e
Sound from
guitar, mic, etc.
Sound from
guitar, mic, etc.
3
At the EZ-RECORDING [Mixdown] Selecting Effect Patch dialog box,
use the CURSOR buttons or the
ENTER
then press the
the selection, press the
In this example, select the Final RV patch from System Effects.
fig.10-60c.e.eps_50
4
At the EZ-RECORDING [Mixdown] Finish Getting Ready for Recording
dialog box, press the
box.
60
Insertion Effects
Effects
Mix
System Effects
Effects
Mix
VALUE
TIME/VALUE dial to move the cursor,
ENTER button to select the effect patch. After making
NEXT button or click Next.
NEXT button or click Finish to close the dialog
To line output,
headphones, or other output
To line output,
headphones, or other output
Keeping the INPUT INST
(mic and guitar input) or
INPUT AUX (auxiliary and
digital input) faders raised
may allow the introduction
of noise into the sound.
During mixdown, either
mute any unused inputs, or
lower the faders for those
inputs.