Danfoss iC7 Series Operating Manual page 30

iC7 Series PROFINET
Operating Guide
BUS
WARN
READY
FAULT
Blind Panel
Illustration 13: Control Panel Options
For more information on control panels, refer to the application guides.
•
The LED labeled ST shows the module status.
•
The LED labeled X1 shows the network status on Ethernet port X1.
•
The LED labeled X2 shows the network status on Ethernet port X2.
Table 19: Fieldbus Indicator LED Functions
LED label Status
ST DCP blink
Not configured
IO connection faulted
Configuration mismatch
Configured/No IO connection
All IO connections OK
DCP blink
X1/X2
Link down
Invalid configuration/Duplicated
IP address
Link up
30 | Danfoss A/S © 2023.06
BUS
1420
rpm
Speed
WARN READY FAULT
OK
REM
LOC
OFF RUN
Control Panel 2.8
LED pattern Description
Flashing yellow PROFINET discovery protocol active, 3 s flashing.
Off PROFINET not configured.
Steady red A PROFINET IO connection has faulted.
Flashing red PROFINET configuration mismatch.
Flashing green Device is configured from PLC master but no IO connection
has been established.
Solid green PROFINET IO connection to device established.
Flashing yellow PROFINET discovery protocol active, 3 s flashing.
Off –
Solid red IP configuration error
Solid green Ethernet link is active.
Troubleshooting
AQ408626183394en-000101 / 136R0280