HOMCOM A91-234V00 Assembly Instruction Manual page 47

3. Slide both guiding tubes (07) through the
rubber rings (48) and into the holes of the rear
stabiliser (3) – tighten from the bottom side using
two curve washers (33) and two head hex bolts
(22).
4. Place the weight stack (64) into position.
Ensure the guiding tubes (07) are fed through
the holes.
5. Place the bushing for
the weight stack (57) onto
the select bar (19) –
secure in place using the
fixed pin (41). Place the
weight stack (63) on the
select bar (19), then place
a flat washer (37) onto the
weight stack (63).
6. Insert the select pin (32) through the weight
stack (64) and into the hole of the select bar
(19).
-14-