Operation Safety - Kemppi PROMIG 511 Operation Instructions Manual

1.3.

OPERATION SAFETY

Please study these Operation safety instructions and respect them when installing, operating and
servicing the machine.
Welding arc and spatters
Welding arc hurts unprotected eyes. Be careful also with reflecting arc flash. Welding arc and
spatter burn unprotected skin. Use safety gloves and protective clothing.
Danger for fire or explosion
Pay attention to fire safety regulations. Remove flammable or explosive materials from welding
place. Always reserve sufficient fire-fighting equipment on welding place. Be prepared for
hazards in special welding jobs, eg. for the danger of fire or explosion when welding container
type work pieces. Note! Fire can break out from sparks even several hours after the welding
work has been finished!
Mains voltage
Never take welding machine inside a work piece (eg. container or truck). Do not place welding
machine on a wet surface. Always check cables before operating the machine. Change defect
cables without delay. Defect cables may cause an injury or set out a fire. Connection cable must
not be compressed, it must not touch sharp edges or hot work pieces.
Welding power circuit
Isolate yourself by using proper protective clothing, do not wear wet clothing. Never work on
a wet surface or use defect cables. Do not put MIG-gun or welding cables on welding machine
or on other electric equipment. Do not press MIG-gun switch, if the gun is not directed towards
a work piece.
Welding fumes
Take care that there is sufficient ventilation during welding. Take special safety precautions
when welding metals which contain lead, cadmium, zinc, mercury or beryllium.
10 – PROMIG 501, PROMIG 511/0537 © KEMPPI OY