Preface; Introduction; Product Introduction; Operation Safety - Kemppi PROMIG 200 ML Operation Instructions Manual

1. PREFACE

1.1. Introduction

Congratulations on having purchased this product. Properly installed Kemppi products
should prove to be productive machines requiring maintenance at only regular intervals.
This manual is arranged to give you a good understanding of the equipment and its safe
operation. It also contains maintenance information and technical specifi cations. Read
this manual from front to back before installing, operating or maintaining the equipment
for the fi rst time. For further information on Kemppi products please contact us or your
nearest Kemppi distributor.
The specifi cations and designs presented in this manual are subject to change without
prior notice.
In this document, for danger to life or injury the following symbol is used:
Read the warning texts carefully and follow the instructions. Please also study the Ope-
ration safety instructions and respect them when installing, operating and servicing the
machine.

1.2. Product introduction

PROMIG 200 ML is a mobile wire feed unit designed for dock yards and heavy metal
industry. PROMIG wire feed units are used with PRO multi-function power sources.
Due to its operational properties and mechanical durability, PROMIG 200 is very sui-
table for fl ux-cored electrode welding with long intermediate cables. Operation of wire
feed unit is controlled and adjusted with microprocessor. The Tacho generator of wire
feed motor enables an accurate and even adjustment of wire feed speed.
PROMIG 200 is designed to be used with fi ller wire reels of max 200 mm (5 kg).
This equipment's electromagnetic compatibility (EMC) is designed for use in an
industrial environment. Class A equipment is not intended for use in residential
location where the electrical power is provided by the public low-voltage supply
system.

1.3. Operation safety

Please study these Operation safety instructions and respect them when installing, ope-
rating and servicing the machine.
Welding arc and spatters
Welding arc hurts unprotected eyes. Be careful also with refl ecting arc fl ash. Welding
arc and spatter burn unprotected skin. Use safety gloves and protective clothing.
Danger for fi re or explosion
Pay attention to fi re safety regulations. Remove fl ammable or explosive materials from
welding place. Always reserve suffi cient fi re-fi ghting equipment on welding place. Be
prepared for hazards in special welding jobs, eg. for the danger of fi re or explosion
when welding container type work pieces. Note! Fire can break out from sparks even
several hours after the welding work has been fi nished!
© KEMPPI OY PROMIG 200ML/0509 – 3