Advertisement
C onnecting A lar m I nput/O utput
A lar m I nput
A L A R M -I N
3
IPC
A L A R M -G N D
4
A lar m O utput
A L A R M -C O M
IPC
A L A R M -O P E N
Weather Resistant Network Coupler
1. Loosen the nut from the Weather Resistant Network Coupler.
2. Run ethernet cable through coupler, then attach a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
Installation
Before beginning installation, make sure that the wall or ceiling is
strong enough to withstand 3 times the weight of the camera. The
mounting steps are as follows:
1. Attach the drill template to
the place where you want to
install the camera, then drill
the screw holes and 1 cable
hole according to the drill
template.
1A. Rotate the trim ring counterclockwise to remove.
2. Loosen the screws to open
the lower dome and then
loosen the lock screw to
remove the mounting base.
1
+
2
P ower S our ce
2.92"
Sensor
+
A lar m
-
-
2.92"
3
Advertisement
