Table of Contents
Advertisement
Connect i ng A l ar m I nput /Out put
A l ar m I nput
A L A RM -I N
IPC
A L A RM -GND
A l ar m Out put
A L A RM -COM
IPC
A L A RM -OPEN
Weather Resistant Network Coupler
1.
1. Loosen the nut from the Weather Resistant Network Coupler,
2. Run ethernet cable through coupler, then attach a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
Installation
Before beginning installation, make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera. The mounting steps are as follows:
1. Install a MicroSD Card
2. Attach the drill template to the place where you want to install the camera, then drill
4 screw holes and 1 cable hole (if you want to route the cables through the mounting
base) according to the drill template.
25.4"/64.6mm
3
4
1
+
2
Power Sour ce
.2"
5mm
3
Sensor
+
A l ar m
-
-
2.
3.
Advertisement
Table of Contents
