Advertisement
Weather Resistant Network Coupler
1. Loosen the nut from the weather resistant network coupler,
2. Run the weather rated ethernet cable through coupler, then attach
a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
Installation
Before beginning installation, make sure that the wall or ceiling is
strong enough to withstand 3 times the weight of the camera. The
mounting steps are as follows:
1. Attach the drill template to
the place where you want to
install the camera, then drill
3 screw holes and 1 cable
hole (if you want to route the
cables through the mounting
base) according to the drill
template
2. Route the cables and connect the power & video cables, use the
rubber plug to fill the gap on the mounting base. then secure the
mounting base to the ceiling or wall with screws.
All manuals and user guides at all-guidesbox.com
3
Advertisement
