Table of Contents
Advertisement
C onnecting A lar m I nput/O utput
A lar m I nput
A L A R M -I N
IPC
A L A R M -G N D
A lar m O utput
A L A R M -C O M
IPC
A L A R M -O P E N
Weather Resistant Network Coupler
1.
1. Loosen the nut from the Weather Resistant Network Coupler,
2. Run ethernet cable through coupler, then attach a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
Installation
Before beginning installation, make sure that the wall or ceiling is
strong enough to withstand 3 times the weight of the camera. The
mounting steps are as follows:
1. Attach the drill template to
the place where you want to
install the camera, then drill
4 screw holes and 1 cable
hole (if you want to route the
cables through the mounting
base) according to the drill
template
2. Route the cables and connect the power & video cables, use the
rubber plug to fill the gap of the mounting base. then secure the
mounting base to the ceiling or wall with screws.
3
4
1
+
2
P ower S our ce
2.54"
Sensor
+
A lar m
-
-
2.
2.54"
3
3.
.2"
Advertisement
Table of Contents
