Accent Spot Q4
Angle Adjustment
You can adjust the angle of the device with the 2 adjustment screws (02).
01) Turn the 2 adjustment screws (02) counterclockwise to release them.
02) Tilt the device to the desired angle (see Fig. 06).
03) Turn the 2 adjustment screws (02) clockwise to tighten them. Make sure that the device cannot
move freely after the 2 adjustment screws (02) are tightened.
Beamshaper Installation
The device is delivered with 2 beamshapers (10° and 40°). To install the beamshapers, follow the steps
below:
01) Put the beamshaper on the lens of the device. The magnets in the beamshaper will keep it in
position.
02) To remove the beamshaper, hold it by the edge and pull it off.
Product code: 42541
13
Fig. 06
Fig. 07