Table of Contents
Advertisement
satellite, sat position is 1. The version of SatCR is either 1.0 or 2.0. Version 1.0 can have up to 8 different users,
version 2.0 can have up to 32, it depends on the LNB and splitter used. SatCR systems are usually installed by
professional experts. An optional satellite splitter is required for multi-users.
For SatCR use, DiSEqC and polarity should be disabled.
If a SatCR LNB is used, please refer to the manual of that LNB to obtain the technical data about User Bands
numbers and corresponding frequencies.
NOTE: SatCR can only work in combination with an optional multi-output satellite splitter and a SatCR
LNB, example STRONG type SRT L780 (max. 4 users). Note: SatCR cannot be combined with any
other DiSEqC function. SatCR systems are mainly installed by professional experts.
IF Channel
Centre Freq
Sat Position
Version
Select SAVE to store the settings.
7.1.4 Single satellite search
To search just one satellite, selected before in the Satellite List.
Satellite:
FTA Only:
NOTE: Scrambled channels can not be watched with this receiver.
Scan Channel:
Scan Mode:
Auto Scan
Pre-set Scan
Accurate scan
Network Search
Tuner
After configuring, select Search and press OK to start scanning with the selected settings.
Your receiver will now perform an (automatic) channel search with the scanning progress shown on screen.
During the channel search you can quit the scan process with . When the process has been completed, all
found channels will be stored. Press OK to confirm and leave the menu by pressing with
proceed to editing parameters by pressing
Multi-Satellites Search:
To scan more than one satellite in one go.
Manual select: Select the User band ID number according to the specifications of
your SatCR LNB. NOTE: Any SatCR LNB user in the chain needs a different Channel ID
number.
Manual select: Select the Centre Frequency according to the specifications of your
SatCR LNB, corresponding with the correct IF Channel. NOTE: Any SatCR LNB user in
the chain needs a different Centre Frequency.
Select the number assigned to the satellite by the installer. If you only use only one
SatCR LNB, (for one satellite) then the number is 1.
The version of SatCR is either 1.0 or 2.0. Version 1.0 can have up to 8 different users,
version 2.0 can have up to 32, it depends on the LNB and signal splitter used.
Select a satellite with t u to be scanned. You may have selected more than one
satellite in the satellite list.
Press t u to select No to search for scrambled and free channels or Yes to search for
Free to Air channels only.
Press t u to select TV+Radio, TV Channel or Radio
Use t u to select mode auto scan, pre-set scan or accurate Scan.
This the default mode and should be used first.
All stored transponders in the memory will be scanned.
A few satellites carry a list with transponder parameters of all transponders on that
satellite. It can be useful if the auto scan does not find an expected channel.
This is a blind scan mode, in which the scan process probes certain frequencies to
find unknow parameters of a Satellite.
Use t u to select Yes or No. Some providers use more than one transponder to
transmit their Pay-TV programmes. Select Yes and one of those transponders and
it will find the corresponding transponders as well. Note: This is only applicable for
scrambled channels, which can not be seen with this receiver.
Not applicable for this receiver.
only once.
20
several times, or
Advertisement
Table of Contents
