Hardware Setup - StarTech.com 129N-USBC-KVM-DOCK Instruction Manual

Hardware Setup

1. Connect the Power Adapter (included with the KVM Dock) from an AC outlet, to the
DC 20V Port, located on the KVM Dock.
2. Connect the desired USB Peripheral Devices to the USB-A Data Ports and USB-C
Data Ports, located on the dock.
IMPORTANT NOTE: For hot-key support, the keyboard must be connected to the
USB-A Keyboard/Data Port.
3. Connect up to two DisplayPort Enabled Monitors to the DisplayPort Video Ports
on the dock.
4. Press the Power Switch into the ON position.
5. Connect a USB-C Host Cable (included with the KVM Dock) to each of the USB-C
Host Ports (PC 1 & PC 2) located on the KVM Dock, and to a USB-C Port on each
of the Host Computers. If the Host Computer is running Windows and has Internet
access it will automatically detect the device and install all the required drivers.
If you're running a non-Windows operating system or the drivers do not
automatically install, on one or both, of your computers, disconnect the USB-C Host
Cable from the Host Computer(s) that's failing installation, then:
a. Navigate to:
www.StarTech.com/129N-USBC-KVM-DOCK
www.StarTech.com/129UE-USBC-KVM-DOCK
and click the Drivers/Downloads tab.
b. Under Driver(s), download the Driver Package for your operating system, and follow
the steps outlined in the Installation guide, that's included in the Driver Package.
c. Once the installation has completed, reconnect the Host Computer(s) to the
KVM Dock.
Note: Drivers must be installed on all Host Computer(s) connected to the
KVM Dock.
Instruction manual
or
3