Stopping The Chiller - Conair PCW-1.5 User Manual

3 - 1 8 l I n s t a l l a t i o n
S t o p p i n g t h e P L C C h i l l e r
To stop the chiller, press the Stop button on the control panel.
Run Stop Manual
| |
The compressor shuts off after a pumpdown and the pump shuts off 10 seconds
later. This allows the chiller to pump down the refrigerant system and store the
refrigerant in the receiver (water-cooled models) or condenser (air-cooled models.
This prolongs the life of the compressor.
i
NOTE: If you try to restart the chiller immediately after stopping it, pressing the Run
arrow on the display starts the pump (the Process Pump light on the control panel lights)
but the compressor will not turn on for three minutes. After three minutes the compres-
sor turns on and the Compressor light on the control panel lights. This allows the
Compressor's internal temperatures to lower, making restart easier, and prolonging the
life of the compressor.
If the chiller is not working properly at any time, stop the chiller and refer to the
Troubleshooting section. If you do not encounter any problems, proceed to the
Operation section.
IMPORTANT: In the event the chiller needs to be stopped immediately, press the red chiller
Stop button on the control panel.
|