Preparing For Installation - Conair PCW-1.5 User Manual

i
NOTE: Air-cooled models must
be positioned so that the con-
denser air inlet is no warmer
than 95°F {35°C} and the con-
denser air outlet is not blocked
or restricted in any way. Refer
to high ambient models if
higher than 95°F {35°C}.
3 - 4 l I n s t a l l a t i o n
P r e p a r i n g f o r I n s t a l l a t i o n
Plan the location for the chiller and prepare the area properly.
Position the chiller as close to the process machine as possible. Place the chiller in
position near the process machine so that fluid lines can be connected from the
process machine to the chiller and back.
Alternate
locations
Make sure the area where the chiller is installed has:
Ì Ì A grounded power source.
Check the chiller's serial tag for the correct amps, voltage, phase, and
cycle. All wiring should be completed by qualified personnel and comply
with your region's electrical codes.
Ì Ì Clearance for safe operation and maintenance.
Make sure there is two feet clearance around the chiller for proper
operation. After positioning lock casters to prevent chiller from mov-
ing. For maintenance and servicing, be sure there is enough clearance
to remove all access panels completely.
24 inches
{610 mm}
24 inches
{610 mm}
Size 1
Ì Ì Available water source.
If installing a water-cooled unit, makes sure water source is plumbed
to chiller installation location. High points in plumbing require vent
valves; low points require drain valves.
Process machine
24 inches
{610 mm}
24 inches
{610 mm}
24 inches
{610 mm}
24 inches
{610 mm}
Size 2 and Size 2R air cooled units
Chiller
24 inches
{610 mm}
24 inches
{610 mm}