Club Car Electric Precedent 2008 Maintenance And Service Manual page 54

6
Brake Shoe Removal
7. Remove brake drums and badly worn brake shoes.
7.1. On the back of each brake cluster assembly, locate the heads of two brake shoe retainer pins. It may be
necessary to remove sealant material around the head of each pin.
1
636
Figure 6-1 Loosen Turnbuckle
7.2. Insert a 1/2 inch x 5/8 inch cold chisel (1) under the head (2) of each pin and shear them off as illustrated
(Figure 6-2, Page 6-2). This will release the shoes from the backing plate, allowing them to pivot away
from the inside of the brake drum (3), which should then allow the brake drum to be pulled free. After
completing step 8, skip step 9.
NOTE: Although step 8 allows easier access to the brake shoes, it is not imperative to do so in order to remove
the brake shoes.
8. Remove the axle.
8.1. Using 90° snap ring pliers (CCI P/N 1012560), remove the axle retaining ring (1) (Figure 6-3, Page 6-2).
8.2. Pull the axle shaft (2) from the axle tube (Figure 6-3, Page 6-2).
2
2400-23600-10221
Figure 6-3 Remove Axle Retaining Ring
Page 6-2 2008 Electric Precedent Maintenance and Service Manual
5
1400-18100-10220
1
WHEEL BRAKE ASSEMBLIES
1
Figure 6-2 Shoe Retainer Pins