Club Car Electric Precedent 2008 Maintenance And Service Manual page 203

IQ DISPLAY MODULE (IQDM) AND IQDM-P
DIAGNOSTICS: IQ SYSTEM
4.3.1. Disconnect the square four-pin connector (3) from the speed controller.
4.3.2. Connect the handset cord to the handset.
4.3.3. Connect the other end of the handset cord (without the adapter) (4) to the four-pin connector of the
speed controller (2) (Figure 13-8, Page 13-21).
4.3.4. Connect the vehicle batteries, positive (+) cable first.
4.3.5. If the handset functions when connected directly to the speed controller, the adapter plug or vehicle
wire harness should be thoroughly tested. See Test Procedure 2 – Handset Cord Adaptor on
page 13-19. See Section 11 — IQ System Troubleshooting .
4.4. Replace electronics module cover. See Electronics Module Cover – Style A Battery Configuration on
page 15-5 or Electronics Module Cover – Style B and C Battery Configurations on page 15-6.
701
Figure 13-8 IQDM Connector On Speed Controller
2008 Electric Precedent Maintenance and Service Manual
13
Test Procedures
Page 13-21