Pedal Group Installation - Club Car Electric Precedent 2008 Maintenance And Service Manual

5
Pedal Group

PEDAL GROUP INSTALLATION

1. Place the MCOR on the pedal group and secure with two screws (1) (Figure 5-3, Page 5-3). Tighten screws to
23 in-lb (2.6 N·m).
2. Connect the wire harness (12) to the MCOR (11) (Figure 5-2, Page 5-2).
NOTE: Connectors will only fit together in one orientation.
3. Position the pedal group in vehicle and secure with two screws (2) on the driver side and two screws (1)
on the passenger side. Tighten driver side screws (2) to 12 ft-lb (16.3 N·m). Tighten passenger side screws
(1) to 5 ft-lb (6.8 N·m).
4. Remove the turnbuckle (6) and apply Loctite 242 to the threaded ends of both the rod from the pedal group (8)
and the brake actuator rod (9). Connect the rods using the turnbuckle (6). Ensure the ends of the brake cables do
not slip out of the brake equalizer during this procedure.
5. Adjust the brake cable equalizer tension. See Brake Cable Equalizer Adjustment on page 6-10.
6. Place floor cover plate (7) over the floor opening (Figure 5-2, Page 5-2).
7. Install the floor mat (2) over the pedal group. Make sure tabs on floor mat sides are beneath the sill (3). Tighten
screws (1) to 53 in-lb (6 N·m) (Figure 5-1, Page 5-1).
Page 5-6 2008 Electric Precedent Maintenance and Service Manual
ACCELERATOR AND BRAKE PEDAL GROUP