Club Car Electric Precedent 2008 Maintenance And Service Manual page 301

MOTOR (MODEL EJ4-4001)
WARNING
• Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic floor
jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold vehicle in raised
position. Use approved jack stands of proper weight capacity to support the vehicle and chock
the wheels that remain on the floor. When not performing a test or service procedure that requires
movement of the wheels, lock the brakes.
729
Figure 19-1 Lift Vehicle with Floor Jack
5. Remove both rear wheels.
6. Remove the nut, cup washer, and bushing from the bottom side of the shock absorber. Compress the shock
absorber (pushing upwards) to move it out of the way (Figure 19-3, Page 19-3).
7. Remove the nuts and bolts mounting the rear leaf springs to the shackles.
8. To gain easier access to the motor, lower the transaxle as low as it will go. If more room is needed, remove the
jack from beneath the transaxle and allow the springs to rest on the floor (Figure 19-3, Page 19-3).
731
Figure 19-3 Lower Axle
9. Remove the four bolts that mount the motor to the transaxle (Figure 19-24, Page 19-15). See following
CAUTION.
682
Figure 19-2 Vehicle Supported on Jack Stands
2008 Electric Precedent Maintenance and Service Manual
19
Motor
Page 19-3