Tow/Run Switch Installation; Tow/Run Switch - Style B And C Battery Configurations; Testing The Tow/Run Switch; Tow/Run Switch Removal - Club Car Electric Precedent 2008 Maintenance And Service Manual

15
Tow/Run Switch – Style B and C Battery Configurations
5. Disconnect the pink wire (3) and blue wire (4) remove switch.

TOW/RUN SWITCH INSTALLATION

1. Installation is reverse of removal. Make sure flat on switch is aligned with the flat on bracket. Tighten Tow/Run
switch boot/hex nut (1) to 16 in-lb (1.8 N·m) (Figure 15-7, Page 15-8).
2. Install the electronics module cover. See Electronics Module Cover Installation on page 15-5.
3. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first. Tighten
battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
1
2
4
3
708
Figure 15-7 Tow/Run Switch – Style A Battery
Configuration
TOW/RUN SWITCH – STYLE B AND C BATTERY CONFIGURATIONS
See General Warnings on page 1-1.

TESTING THE TOW/RUN SWITCH

See Test Procedure 6 – Tow/Run Switch on page 12-19.

TOW/RUN SWITCH REMOVAL

1. Disconnect the battery cables and discharge the controller as instructed. See WARNINGS "To avoid
unintentionally starting..." and "After disconnecting the batteries, wait 90 seconds..." in General
Warnings on page 1-1.
2. Remove the bolt (11) that secures the electronics module to the battery bucket (Figure 15-12, Page 15-16).
3. Pull electronics module forward and disconnect the pink wire (3) and light green wire (4) from switch.
4. Remove Tow/Run switch boot/hex nut (1) (Figure 15-8, Page 15-9).
5. Remove Tow/Run switch (2) from electronics module.
Page 15-8 2008 Electric Precedent Maintenance and Service Manual
ELECTRICAL COMPONENTS