Ferrite Beads - Ce Mark Vehicles - Club Car Electric Precedent 2008 Maintenance And Service Manual

15
Ferrite Beads – CE Mark Vehicles
FERRITE BEADS – CE MARK VEHICLES
These beads bring the vehicle into compliance with EMC requirements for use in the European Union.
1. This bead goes around 4 wires (6 Ga. White, 6 Ga. Green, 10 Ga. Orange, 10 Ga. Blue) near the controller.
2. This bead goes around 2 wires (10 Ga. Orange and 10 Ga. Blue) as close as reasonable to the controller.
3. This bead goes around 2 wires (10 Ga. Orange and 10 Ga. Blue) near the motor just before the wires split to terminals F1 and F2.
4. This bead goes around the motor speed sensor harness (black conduit) just before the three-pin connector at the motor.
5. This wire tie goes around the motor speed sensor harness (black conduit) and 2 wires (6 Ga. White and 6 Ga. Green) between the bead
(item 4) and three-pin connector.
6. This wire tie goes around 4 wires (6 Ga. White, 6 Ga. Green, 10 Ga. Orange, 10 Ga. Blue) between the bead (item 1) and controller.
1314
Page 15-26 2008 Electric Precedent Maintenance and Service Manual
1
Figure 15-15 Ferrite Bead Placement For Precedent Vehicles
ELECTRICAL COMPONENTS
3