Electronics Module Cover - Styleb And C Battery Configurations; Electronics Module Cover Removal; Electronics Module Cover Installation - Club Car Electric Precedent 2008 Maintenance And Service Manual

Electronics Module Cover – Style B and C Battery
15
Configurations
1
706
Figure 15-5 Electronics Module Cover
ELECTRONICS MODULE COVER – STYLE
B AND C BATTERY CONFIGURATIONS
See General Warnings on page 1-1.
The electronics module cover needs to be removed to gain access to the speed controller, Tow/Run switch, and
onboard computer.

ELECTRONICS MODULE COVER REMOVAL

1. Disconnect the battery cables and discharge the controller as instructed. See WARNINGS "To avoid
unintentionally starting..." and "After disconnecting the batteries, wait 90 seconds..." in General
Warnings on page 1-1.
2. Remove the two plastic rivets (1) that secure the access panel (2) to the vehicle (Figure 15-6, Page 15-7).
3. Remove cover (5) by first releasing the two hooks (4) that secure the cover to the battery bucket. Then, manuever
the cover to release the four tabs (3) from the matching holes in the hood of the battery bucket.

ELECTRONICS MODULE COVER INSTALLATION

1. Install cover (5) by first hooking the four tabs (3) into the matching holes in the hood of the battery bucket (Figure
15-6, Page 15-7). Then, use the two hooks (4) to secure the cover to the battery bucket.
2. Place access panel (2) on vehicle and secure with the two plastic rivets (1). See following CAUTION.
Page 15-6 2008 Electric Precedent Maintenance and Service Manual
2
ELECTRICAL COMPONENTS