Advertisement
Identifier
Status
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
NOTE:
Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program
after you replace the system board.
NOTE:
Replacing the system board removes any changes you have made to the BIOS using the BIOS setup program. You must
make the appropriate changes again after you replace the system board.
NOTE:
Before disconnecting the cables from the system board, note the location of the connectors so that you can reconnect
the cables correctly after you replace the system board.
Identifier
Status
Prerequisites
1
Remove the
base
cover.
2
Remove the battery.
3
Remove the
memory
modules.
4
Remove the
wireless
card.
5
Remove the
solid-state drive/Intel
6
Remove the
heat
sink.
Identifier
Status
Procedure
1
Remove the three screws (M2.5x6) that secure the right hinge to the system board.
2
Open the right hinge.
74
Removing the system board
GUID-B54497E8-5AD5-4FF9-AD4A-F32FDBEDE1E8
Released
Removing the system board
computer. After working inside your computer, follow the instructions in
GUID-427504E6-68FA-4426-A9A5-7B8411756416
Released
Optane.
GUID-E608354B-1E88-4F97-9415-3D182D1377BD
Released
35
After working inside
www.dell.com/
Advertisement
