Specifying Paper Size Using The Operation Panel - Ricoh AP204 Operator's Manual

Paper and Other Media
Important
Make sure that the stack of paper is
no higher than the top-most limit
mark (T) inside the tray.
The front and side guides should be
set to the correct paper size to avoid
paper feed problems.
Do not load different kinds of pa-
per in the tray at a time.
D
Slide the paper tray completely
into the printer.
Important
Be sure to insert the paper tray
completely. Otherwise, paper
misfeeds might occur, or the
5 front cover might touch the pa-
per tray.
52
Specifying paper size using the
operation panel
Use the following procedure to specify
the paper size from the printer's op-
eration panel after loading custom size
paper into the standard paper tray.
Note
You can set the custom paper in the
standard tray (tray 1) only.
To switch to the tray 1, => P54
"Switching between Paper Trays".
The custom paper size setting is
cleared when the printer is turned
off.
After pressing a key, wait until the
display changes as described before
performing the next key operation.
A
Press { { { { { Media} } } } } .
Power On Line
Error
Menu Escape
Media
The "Media" menu appears.
<Media>
1.Paper Tray
B
{U} {U} {T} {T}
Use {U} {U} {U} and {T} {T} {T} to display "2. Pa-
per Size," and then press { { { { { Enter} } } } } .
<Media>
2.Paper Size
The "Paper Size" menu appears.
<Paper Size>
*Auto Detect
Data In
Reset
Enter
TPOS050E
U
T
U
T
U
T