Ricoh AP204 Operator's Manual page 95

Troubleshooting
E
Hold the inset grip of the photo-
conductor unit, pull it straight up,
and remove it from the printer.
Important
Exposing the photoconductor
unit to light for too long can re-
duce its performance. Clean the
charge wire as quickly as pos-
sible.
F
6
Use the wire brush to clean off the
charge wire. Insert the wire brush
between the case and guide (1 1 1 1 1 ),
and then move it left and right (2 2 2 2 2 ).
76
G
Insert the photoconductor unit so
that the protruding green axles on
both sides are aligned with the
tracks inside the green lock levers.
Lower it until the gears mesh se-
curely.
TPOH570E
Important
When inserting the phot-
oconductor unit, be careful not
to damage the surface of it.
H
Return the green lock levers to
their original positions.
Important
TPOH710E
Do not return lock levers with
force. If you cannot lock them
easily, pull the photoconductor
unit from the printer. Then rein-
sert it again until the gears mesh
securely. After that, try returning
the levers to their original posi-
tions.
TPOH230E
TPOH590E