Table of Contents
Advertisement
H
If you use NetWare, select the frame type for NetWare. Select one of items
below if necessary.
• Auto Select (Default)
• Ethernet 802.3
• Ethernet 802.2
• Ethernet2
• Ethernet SNAP
Note
Usually, use the default setting ("Auto Select"). However if you select "Auto
Select", the frame type detected by the printer first is adopted. If your net-
work can use more than two frame types, the printer fails to select the cor-
rect frame type, if the "Auto Select" is selected. In this case, select the ap-
propriate frame type.
1 Press {U} {T}
{U} {T}
{U} {T}
{U} {T}
{U} {T} until the following message appears.
<System Menu>
38. Frame NW
2 Press { { { { { Enter} } } } } .
The current setting appears on the panel display.
<Frame NW>
*Auto Select
{U} {T}
{U} {T}
3 Press {U} {T}
{U} {T}
{U} {T} until the frame type you want to use appears.
4 Press { { { { { Enter} } } } } .
You have completed the printer's network settings.
5 Press { { { { { On Line} } } } } .
This returns to the normal display screen.
I
Print the configuration page to check settings you have made.
1 Press { { { { { Menu} } } } } .
2 Press {U} {T}
{U} {T}, until the following message appears.
{U} {T}
{U} {T}
{U} {T}
<Menu>
List Print
3 Press { { { { { Enter} } } } } .
4 Check if the following message appears. If not, press {U} {T}
following message appears.
<List Print>
Config.Page
5 Press { { { { { Enter} } } } } .
The following message appears.
<Config.Page>
Press # key
Setting Up the Printer for Network with the Operation Panel
U
U
T
U
T
U
T
U
T
{U} {T}
{U} {T}
{U} {T} until the
{U} {T}
3
27
Advertisement
Chapters
Table of Contents
Troubleshooting
